Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Effectiveness of Aluminium Foil Helmets
#1
1: Electrical Engineering and Computer Science department, MIT.
2: Media Laboratory, MIT.

Abstract

Among a fringe community of paranoids, aluminum helmets serve as the protective measure of choice against invasive radio signals. We investigate the efficacy of three aluminum helmet designs on a sample group of four individuals. Using a $250,000 network analyser, we find that although on average all helmets attenuate invasive radio frequencies in either directions (either emanating from an outside source, or emanating from the cranium of the subject), certain frequencies are in fact greatly amplified. These amplified frequencies coincide with radio bands reserved for government use according to the Federal Communication Commission (FCC). Statistical evidence suggests the use of helmets may in fact enhance the government's invasive abilities. We speculate that the government may in fact have started the helmet craze for this reason.

Introduction

It has long been suspected that the government has been using satellites to read and control the minds of certain citizens. The use of aluminum helmets has been a common guerrilla tactic against the government's invasive tactics [1]. Surprisingly, these helmets can in fact help the government spy on citizens by amplifying certain key frequency ranges reserved for government use. In addition, none of the three helmets we analyzed provided significant attenuation to most frequency bands.

We describe our experimental setup, report our results, and conclude with a few design guidelines for constructing more effective helmets.

Experimental Setup

We evaluated the performance of three different helmet designs, commonly referred to as the Classical, the Fez, and the Centurion. These designs are portrayed in Figure 1. The helmets were made of Reynolds aluminium foil. As per best practices, all three designs were constructed with the double layering technique described elsewhere [2].

A radio-frequency test signal sweeping the ranges from 10 Khz to 3 Ghz was generated using an omnidirectional antenna attached to the Agilent 8714ET's signal generator.

A network analyser (Agilent 8714ET) and a directional antenna measured and plotted the signals. See Figure 2.

Because of the cost of the equipment (about $250,000), and the limited time for which we had access to these devices, the subjects and experimenters performed a few dry runs before the actual experiment (see Figure 3).

The receiver antenna was placed at various places on the cranium of 4 different subjects: the frontal, occipital and parietal lobes. Once with the helmet off and once with the helmet on. The network analyzer plotted the attenuation betwen the signals in these two settings at different frequencies, from 10Khz to 3 Ghz. Figure 4 shows a typical plot of the attenuation at different frequencies.

Results

For all helmets, we noticed a 30 db amplification at 2.6 Ghz and a 20 db amplification at 1.2 Ghz, regardless of the position of the antenna on the cranium. In addition, all helmets exhibited a marked 20 db attenuation at around 1.5 Ghz, with no significant attenuation beyond 10 db anywhere else.

Conclusion

The helmets amplify frequency bands that coincide with those allocated to the US government between 1.2 Ghz and 1.4 Ghz. According to the FCC, These bands are supposedly reserved for ''radio location'' (ie, GPS), and other communications with satellites (see, for example, [3]). The 2.6 Ghz band coincides with mobile phone technology. Though not affiliated by government, these bands are at the hands of multinational corporations.

It requires no stretch of the imagination to conclude that the current helmet craze is likely to have been propagated by the Government, possibly with the involvement of the FCC. We hope this report will encourage the paranoid community to develop improved helmet designs to avoid falling prey to these shortcomings.

Acknowledgments

The authors would like to thank Andy (Xu) Sun of the MIT Media Lab for helping with the equipment, Professor George Sergiadis for lending us the antennae, and Professor Neil Gershenfeld for allowing us the use of his lab equipment. (Please direct any queries to the authors, NOT these folks)

There's also an informative video, courtesy of Discover Channel's Daily Planet.

 http://people.csail.mit.edu/rahimi/helmet/
Reply

#2
I prefer to use a collander. It's much more durable, and I think, makes a better fashion statement.
Reply

#3
gw_3warrioricon_3jump
Reply

#4
  Sorry but Collandars have holes in them so the crazy beams will getcha!~  Gotta have solid aluminum foil...   Or solid cheese.

 
Reply

#5
The article did surprise me because I thought aluminum foil would shield you from the mind control frequencies. I know it reflects the microwave frequency and that’s why you can’t use it in a microwave. So you would think it would reflect all frequencies.
Reply

#6
My understanding is that aluminum will deflect EMF but it also needs to be grounded. 
Reply

#7
You can’t use it in the microwave because of the metal fibers in aluminum, aluminum is a low grade metal, this is why you should never have aluminum cooking appliances, the metal brakes down while heating up on the stove and lets off toxic vapors, if you use an aluminum fry pan you will notice over time that the bottom gets extremely hot and it thins out. Same reason why soda is sold in aluminum cans, eventually the toxicity and the soda become one, and it’s a brain deadener.
Has anyone ever compared coke in glass to a can? The taste is very different.
I know that asbestos is one of the only substances that can not be penetrated through, this is why they have taken it out of homes, yes once broken it is extremely dangerous to the lungs, yet while intact, they can not use heat sensors or laser sensory equipment through it. Not sure about how it affects other frequencies they use on the people.
Reply

#8
That makes sense Karen. I know what you mean about the taste of beverages in a can. I always try to buy them in glass bottles when available.

I heard that about asbestos before. It makes sense why they want to remove it from buildings. They don’t care our health. They just want to make it easier for mind control frequencies to penetrate buildings.
Reply

#9
Good tip about the asbestos, didn't know that.  I've also wondered if lead paint wasn't removed for the same reason.
Reply

#10
I’m not sure how the lead paint would stop anything, but I do know it was extremely toxic to those who had to work with it.
Reply



Forum Jump:


Users browsing this thread:

Powered By MyBB, © 2002-2025 Melroy van den Berg.